Kenwood Gallery

Share

TS2000

2nd IF Installation – all bands IF tap

TS2k PAT installed in DRU position.
TS2k PAT installed in DRU position.
TS2K power and output - CU3AK
TS2K power and output – CU3AK
TS2k input connection on W1
TS2k input connection on W1

VHF/UHF 2nd Rx function – PAT-V

PAT-V location in VHF/UHF board. Input pick-up point is at input to mixer.
PAT-V location in VHF/UHF board. Input pick-up point is at input to mixer.
Power pick up for PAT Vcc
Power pick up for PAT Vcc
PAT V output cable routing. A small hole has been drilled in the rear panel for the cable to pass through.
PAT V output cable routing. A small hole has been drilled in the rear panel for the cable to pass through.

23cm IF Tap – PAT150MHz

PAT located on top of PA module shielding can
PAT located on top of PA module shielding can
PAT input from CN1 - MMCX connector
PAT input from CN7 – MMCX connector
PAT output cable routing from 1G2 module
PAT output cable routing from 1G2 module

 

TS450/690

TS450 Installation with comments
TS450 Installation with comments
TS450 PAT output connection
TS450 PAT output connection

 

TS480

TS480 PAT installation with USB dongle integrated under the PCB - LB6YD
TS480 PAT installation with USB dongle integrated under the PCB – LB6YD

 

TS850

General view of PAT in TS850
General view of PAT in TS850
TS850 input and output connections
TS850 input and output connections
TS850 PAT RxB connection at L63
TS850 PAT RxB connection at L63

 

TS440

 

TS440 PAT mounting, and connections for input and RxB
TS440 PAT mounting, and connections for input and RxB
TS440 Output cable routing
TS440 Output cable routing